Lenovo RD430 - Manual (Page 97)

6. Fully open the cover latch 1 and slide the server cover to the rear until it is disengaged from the chassis.
Then, lift the server cover off the chassis and set it aside.
Note: It is recommended that you wait three to five minutes to let the server cool before removing
the server cover.
Figure 43. Removing the server cover
Attention: For proper cooling and airflow, install the server cover before turning on the server. Operating the
server for more than 30 minutes with the server cover removed might damage server components.
To reinstall the server cover, see “Reinstalling the server cover and reconnecting cables” on page 174.
Removing and reinstalling the front bezel
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 81.
This topic provides instructions on how to remove and reinstall the front bezel.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• This topic applies only to server models that support 2.5-inch hot-swap hard disk drives.
• Depending on the model, your server might look slightly different from the illustrations in this topic.
To remove and reinstall the front bezel for server models with 2.5-inch hot-swap hard disk drives, do the
following:
Chapter 6 . Installing, removing, or replacing hardware 85