Lenovo RD430 User Manual

Page 125

9. Connect cables depending on your specific server configuration. See “Mini-SAS to mini-SAS signal

What to do next:

• To work with another piece of hardware, go to the appropriate section.

• To complete the installation, go to “Completing the parts replacement” on page 174. Then, you might

need to configure RAID for your server. See “Configuring RAID” on page 70.

Removing the expander card

Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 81.

This topic provides instructions on how to remove the expander card.

Attention:

• The server must have a RAID card and an expander card installed to support more than eight hard

disk drives.

• Ensure that you back up your data before removing the expander card because you might need to

reconfigure RAID and reinstall the operating system after removing the expander card.

Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.

Notes:

• The card might look slightly different from the illustrations in this topic.

• Use any documentation that comes with the expander card and follow those instructions in addition to

the instructions in this topic.

To remove the expander card, do the following:

1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all

power cords from electrical outlets and disconnect all cables that are connected to the server.

2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,

clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.

5. Remove the riser card assembly 1 and lay it upside down on a flat, clean, and static-protective surface.

Chapter 6

Installing, removing, or replacing hardware

113