Lenovo RD430 - Manual (Page 188)

3. If you have removed the cooling shroud, reinstall it. See “Removing and reinstalling the cooling shroud”
on page 91.
4. For server models with 2.5-inch hot-swap hard disk drive bays, if you have removed the front bezel,
reinstall it. See “Removing and reinstalling the front bezel” on page 85.
5. Ensure that the cover latch is in the open position. Place the server cover above the chassis so that
the cover latch is aligned with the cover latch slot in the chassis. Then, lower the server cover onto
the chassis until the cover latch is inserted into its slot and both sides of the server cover engage the
guides on both sides of the chassis.
Figure 136. Installing the server cover
6. Pivot the cover latch 1 to the closed position and slide the server cover to the front of the chassis at the
same time until the server cover snaps into position and the cover latch is completely closed.
Figure 137. Closing the server cover completely
176 ThinkServer RD430 User Guide