Linksys SRW224G4P - Manual (Page 29)

Chapter Configuring the Switch
2 24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
ACL > IP based ACL
ACL > IP based ACL
Target Select the New ACL Name option and enter
an ACL name in the text field provided (with up to 16
characters) . To add rules to an existing ACL, select the
ACL Name option and select an ACL from the drop-down
menu .
Acton An ACL can contain any combination of permit or
deny rules .
Protocol Specifies the protocol type to match as TCP,
UDP or Others, where others indicates a specific protocol
number (0-255) . (Options: TCP, UDP, Others; Default: ANY)
TCP Flags Specify the TCP flag bits in byte 14 of the TCP
header by selecting Set or Unset from the drop-down
menus . The following TCP flags may be specified:
Urg Urgent pointer
Rst Reset
Ack Acknowledgement
Syn Synchronize
Psh Push
Fn Finish
Source/Destnaton Port (0-) Source/destination
port number for the specified protocol type . (Range: 0-
65535)
Use the Source/Destination IP Address option to apply the
ACL rule to an IP address or select the Any option to apply
the rule to all IP addresses .
Source/Destnaton IP Address Enter a source or
destination IP address .
•
•
•
•
•
•
Wldcard Mask Enter the Wildcard Mask for the Source/
Destination IP addresses .
Match CoS Packet priority settings based on the following
criteria:
DSCP DSCP priority level . (Range: 0-63)
Precedence IP precedence level . (Range: 0-7)
Then click the Add to Lst Button
To remove an ACL rule, select an ACL rule from the table
and click Remove .
When all rules are removed from the ACL the ACL is also
removed .
ACL > MAC based ACL
ACL > MAC based ACL
Target Select the New ACL Name option and enter
an ACL name in the text field provided (with up to 16
characters) . To add rules to an existing ACL, select the
ACL Name option and select an ACL from the drop-down
menu .
Acton An ACL can contain any combination of permit or
deny rules .
Use the Source/Destination MAC Address option to apply
the ACL rule to a MAC address or select the Any option to
apply the rule to all MAC addresses .
Source/Destnaton MAC Address Specify a MAC
address (for example, 11-22-33-44-55-66) .
Source/Destnaton Wldcard Mask Hexadecimal mask
for source or destination MAC address .
VLAN ID Specify a VLAN ID . (Range: 1-4094)
•
•