Linksys SRW224G4P - Manual (Page 20)

Chapter Configuring the Switch
1 24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
IP Address Address of the VLAN interface that is allowed
management access . Valid IP addresses consist of four
numbers, 0 to 255, separated by periods . (Default:
12.18.1.24)
Subnet Mask This mask identifies the host address
bits used for routing to specific subnets . (Default:
2.2.2.0)
Default Gateway IP address of the gateway router
between this device and management stations that exist
on other network segments . (Default: 0.0.0.0)
DNS Server Enter the IP address of the DNS server into
the text field . A second DNS address can be specified in
the additional text field provided .
Click Save Settngs to save the changes .
Click Restart DHCP to assign a new IP address using
DHCP .
Setup > Time
Simple Network Time Protocol (SNTP) allows the Switch
to set its internal clock based on periodic updates from a
time server (SNTP or NTP) . Maintaining accurate time on
the Switch enables the system log to record meaningful
dates and times for event entries . If the clock is not set, the
Switch will only record the time from the factory default
set at the last bootup . When the SNTP client is enabled,
the Switch periodically sends a request for a time update
to a configured time server . You can configure up to two
time server IP addresses . The Switch will attempt to poll
each server in the sequence .
Setup > Time
Set Time
Set the system tme manually This option allows you to
set the time and date manually for the Switch .
Set the system tme usng Smple Network Tme
Protocol (SNTP) automatcally
Sets the system clock
automatically using SNTP .
Manual
Hours The hour is entered here .
Mnutes The minutes is entered here .
Seconds The seconds is entered here .
Month The month is entered here .
Day The day is entered here .
Year The year is entered here .
Automatic
Sets the system clock automatically using SNTP .
Tme Zone Set the time zone by selecting it from the
drop-down menu .
Daylght Savngs Enable daylight saving time by
checking the checkbox . Then set USA, Europe, or custom
daylight saving time by clicking the appropriate option .
Tme Set Offset Custom daylight saving time is set by
entering the time difference in minutes into the Time Set
Offset field . Set the date for this offset by entering the day
and month (DD/MM) in the From and To fields .
Recurrng To enable a recurring custom daylight savings
time, check the Recurring checkbox . Set the day, week, and
month the time difference will be recurring (From and To)
by using the drop-down menus . Set the time (From and
To) of the recurrence using the field provided (HH:MM) .
SNTP Servers
Sets the IP address of up to two SNTP servers .
Server 1 Set the IP address of the SNTP server .
Server 2 Set the IP address of an additional SNTP server .
Pollng Internal (1-184 sec) The value entered here
determines the number of seconds between each time
the Switch contacts the SNTP server for an update .