Linksys SRW224G4P - Manual (Page 22)

Chapter Configuring the Switch
18 24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
The following capabilities are supported .
10half Supports 10 Mbps half-duplex operation
10full Supports 10 Mbps full-duplex operation
100half Supports 100 Mbps half-duplex operation
100full Supports 100 Mbps full-duplex operation
1000half Supports 1000 Mbps half-duplex operation
1000full Supports 1000 Mbps full-duplex operation
Sym (Gigabit only) Check this item to transmit and
receive pause frames, or clear it to autonegotiate the
sender and receiver for asymmetric pause frames .
Flow Control Allows automatic or manual selection of
flow control .
Port Broadcast Control
Status To enable broadcast control on a specified port,
mark the Enabled checkbox for that port .
Threshold You can protect your network from broadcast
storms by setting a threshold for broadcast traffic for all
ports . Any broadcast packets exceeding the specified
threshold will then be dropped .
After you modify the required port settings, click Apply .
Port Management > Link Aggregation
You can create multiple links between devices that work
as one virtual, aggregate link (LAG) . An aggregated link
offers a dramatic increase in bandwidth for network
segments where bottlenecks exist, as well as providing a
fault-tolerant link between two devices . You can create up
to four LAGs on the Switch . Each LAG can contain up to
eight ports .
Port Management > Link Aggregation
•
•
•
•
•
•
•
LAG Displays the LAG number .
Descrpton Displays the description assigned to the
interface .
Admnstratve Status Indicates whether the interface is
enabled or disabled .
Type Indicates if a LAG has been manually configured
(static) or dynamically set through LACP .
Lnk Status Displays the status of the link .
Speed Displays the port speed .
Duplex Displays the duplex mode .
Flow Control Displays the flow control .
Create To create a new LAG, click the Create button in the
Create column, then add members to the LAG by clicking
on the Select Member button . The select member screen
for the Link Aggregation opens .
Port Management > Link Aggregation > Select Member
The LAG number is shown in the LAG drop-down menu .
The Ethernet ports are represented by check boxes . Assign
up to 8 ports to the LAG by checking the check boxes of
the ports, then click Apply .
Detal To configure the LAG and the LAG broadcast
control, click the Detal button . The Link Aggregation
detail screen will be displayed .
Port Management > Link Aggregation > Detail