Linksys SPA 900 - Manual (Page 133)

5-28
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 5 Linksys IP Phone Field Reference
Regional Tab
Daylight Saving Time Rule Enter the rule for calculating daylight saving time; it should include the start, end, and save
values. This rule is comprised of three fields. Each field is separated by ; (a semicolon) as
shown below. Optional values inside [ ] (the brackets) are assumed to be 0 if they are not
specified. Midnight is represented by 0:0:0 of the given date.
This is the format of the rule: Start = ; end=; save = .
• The and values specify the start and end dates and times of
daylight saving time. Each value is in this format: / /
[/HH:[mm[:ss]]]
• The value is the number of hours, minutes, and/or seconds to add to the
current time during daylight saving time. The value can be preceded by
a negative (-) sign if subtraction is desired instead of addition. The value
is in this format: [/[+|-]HH:[mm[:ss]]]
• The value equals any value in the range 1-12 (January-December).
• The value equals [+|-] any value in the range 1-31.
• If is 1, it means the on or before the end of the month (in other
words the last occurrence of < weekday> in that month).
• The value equals any value in the range 1-7 (Monday-Sunday). It can
also equal 0. If the value is 0, this means that the date to start or end
daylight saving is exactly the date given. In that case, the value must not be
negative. If the value is not 0 and the value is positive, then
daylight saving starts or ends on the value on or after the date given. If
the value is not 0 and the value is negative, then daylight saving
starts or ends on the value on or before the date given.
• The abbreviation HH stands for hours (0-23).
• The abbreviation mm stands for minutes (0-59).
• The abbreviation ss stands for seconds (0-59).
The default Daylight Saving Time Rule is start=4/1/7;end=10/-1/7;save=1.
DTMF Playback Level Local DTMF playback level in dBm, up to one decimal place.
Defaults to -16.
DTMF Playback Length Local DTMF playback duration in milliseconds.
Defaults to .1.
Inband DTMF Boost Controls the amount of amplification applied DTMF signals.
Choices are OdB, 3dB, 6dB, 9dB, 12dB, 15dB, or 18dB.
Defaults to 12dB.
Field Description