Linksys SPA 900 - Manual (Page 127)

5-22
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 5 Linksys IP Phone Field Reference
Regional Tab
Vertical Service Activation Codes
The following Vertical Service Activation Codes are automatically appended to the dial-plan.
Note Some of the following parameters do not apply to the SPA901.
Interdigit Long Timer
(Not applicable to SPA901)
Long timeout between entering digits when dialing. The interdigit timer values are used
as defaults when dialing. The Interdigit_Long_Timer is used after any one digit, if all
valid matching sequences in the dial plan are incomplete as dialed. Range: 0–64 seconds.
Defaults to 10.
Interdigit Short Timer
(Not applicable to SPA901)
Short timeout between entering digits when dialing. The Interdigit_Short_Timer is used
after any one digit, if at least one matching sequence is complete as dialed, but more
dialed digits would match other as yet incomplete sequences. Range: 0–64 seconds.
Defaults to 3.
Field Description
Field Description
Call Return Code This code calls the last caller.
Defaults to *69.
Blind Transfer Code Begins a blind transfer of the current call to the extension specified after the activation
code.
Defaults to *98.
Call Back Act Code Starts a callback when the last outbound call is not busy.
Defaults to *66.
Call Back Deact Code Cancels a callback.
Defaults to *86.
Cfwd All Act Code Forwards all calls to the extension specified after the activation code.
Defaults to *72.
Cfwd All Deact Code Cancels call forwarding of all calls.
Defaults to *73.
Cfwd Busy Act Code Forwards busy calls to the extension specified after the activation code.
Defaults to *90.
Cfwd Busy Deact Code Cancels call forwarding of busy calls.
Defaults to *91.