Lenovo THINKSERVER 3797 User Manual
Page 66
Table 3. DSA diagnostic messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 7, “Parts listing, ThinkServer RD220 Type 3729, 3779, 3797, and 3798,” on page 231 to
determine which components are customer replaceable units (CRU) and which components are field
replaceable units (FRU).
v
If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Message
number
Component
Test
State
Description
Action
089-802-xxx
CPU
CPU
Stress Test
Aborted
System
resource
availability
error.
10. Replace the following components
one at a time, in the order shown,
and run this test again to determine
whether the problem has been
solved:
a. (Trained service technician only)
Microprocessor ( see “Removing
a microprocessor and heat sink”
on page 216 and “Installing a
microprocessor and heat sink” on
page 218).
11. If the failure remains, collect the data
from the DSA event log and send it to
IBM Service. For information about
contacting and sending data to IBM
Service, see
089-901-xxx
CPU
CPU
Stress Test
Failed
Test failure.
1. Turn off and restart the system if
necessary to recover from a hung
state.
2. Make sure that the DSA code is at the
latest level. For the latest level of DSA
code, go to
3. Run the test again.
4. Make sure that the system firmware is
at the latest level. The installed
firmware level is shown in the DSA
event log in the Firmware/VPD section
for this component. For the latest level
of firmware, go to
and select your system to display a
matrix of available firmware.
5. Run the test again.
6. Turn off and restart the system if
necessary to recover from a hung
state.
7. Run the test again.
(Continued on the next page)
58
ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Hardware Maintenance Manual