Krell Industries S-1000 - Manual (Page 16)

12 Krell S–1000
The S–1000 remote control uses one CR2025 lithium battery, which
is included with the shipment.
To open the battery compartment on the back of the remote control:
1. Place the remote face down on the table.
2. Use your thumbnail or a small jeweler’s or eyeglass screwdriver
to move the small tab toward the center of the remote, while
using your index fingernail or screwdriver to pull down gently on
the slot to the right of the tab. The battery compartment will slide
out.
3. Place the battery, plus side up, in the battery tray.
4. Slide battery compartment back into the remote until you hear a
click.
The remote control is ready for operation.
Do not use a knife or other sharp objects to open the battery compartment;
they will scratch the remote control finish.
Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not to be used for a long period of
time. Battery leakage can damage the remote control.
The S–1000 Surround Preamp/processor remote control provides
access to IR controllable power amplifiers, accesses the system
configuration menu and on screen display (OSD), and a special key
to engage digital room EQ. Other functions on the remote control
duplicate front panel functions.
These keys are not active on the S–1000 remote control: MAIN, Z2, THX.
The LD key (6) on the remote corresponds to the cable button/LED (6) on
the front panel.
The following functions are only accessible from the front panel, and are not
available on the remote control:
RECALL, SAVE.
28 Amp Key (Power Amp Key)
Use this key to operate IR controllable power amplifiers, such as
all Krell Evolution amplifiers.
29 Menu Key
Use this key to access the setup menu and on-screen menu
display.
Remote Control Only Description
See Figure 2 on page 7
BATTERY
INSTALLATION
AND REMOVAL
Notes
Notes
REMOTE ONLY
FUNCTIONS