Kenwood KRF-V6200D - Manual (Page 31)

English
31
DVD 6-channel playback
Using a DVD player or the like equipped with six (5.1) output
channels and this unit, you can enjoy surround sound playback.
Connecting a DVD player which can decode the surround signal
itself is also acceptable.
INPUT SELECTOR
VOLUME CONTROL
VOLUME /o
INPUT MODE
DVD/6CH
Preparations
• Connect your DVD player to the DVD/6CH INPUT
jacks of this unit.
• Turn on all other components that will be used.
• Complete .
œ Select "DVD/6CH" as the input source.
∑ Press [INPUT MODE] to select "6CH INPT".
é Start playback of a DVD disc.
® Adjust the volume.
Notes:
• It is not possible to adjust the speaker level or sound effect
([SETUP], [SOUND], [LISTEN MODE], [ACTIVE EQ] and [TONE] will
not be functional) of the channels separately when this unit is in
the 6CH INPUT mode. Adjust the speaker level with the controls
of the DVD player. Refer to the Instruction manual of the DVD
players for the detailed operating instructions.
• For the powered subwoofer, you can adjust the volume of the
subwoofer using the subwoofer’s own volume control.
Notes:
• Depending on the type of the signal or speaker setting, some
listen modes cannot be selected.
• When playback is started, the sound may be cut or interrupted
before the input source is confirmed as Dolby Digital.
• To enjoy Dolby Digital surround (as well as all the other listen
modes) from a single component, be sure to use a Dolby Digital
compatible source component.
• Dolby Digital or DTS signal having more channels than the
maximum number of playback channels available using this unit’s
current settings is input, downmixing is performed to match the
number of available channels.
• Some Dolby Digital Surround EX compliant discs do not contain
identification signals. For this reason, the receiver may not detect
these discs as Dolby Digital EX when the input mode is set to "F-
AUTO". In this case, set the listen mode to "DOLBY DIGITAL EX".
96kHz LPCM playback 96kHz LPCM playback
This unit is compatible with the 96kHz LPCM playback. To play a
96kHz DVD, set the listen mode to "STEREO".
• In "F-AUTO" input mode, the listen mode will automatically be
STEREO.
• When in "D-MANUAL" input mode (listen mode is not STEREO),
"FS 96kHz" will appear in the display and no sound can be heard
from the speakers.
Press [LISTEN MODE] (the listen mode changes to the "STEREO"
mode) to output sound from the speakers.