Kodak 3000 - Manual (Page 15)

Installing Easy Print Software
May 2000 2-5
A screen appears that allows you to set the parameters for your printer.
14. Select the printer you wish to configure from the Printer list.
15. Select the media to be used in the printer and its width from the
Media lists.
16. Select the type of ink loaded in the printer from the InkType list.
17. Move the slider to set a value for Ink Depletion. The value you set
determines the amount of ink that is applied to the media.
Note: The normal value is 100 percent. Decreasing the
value can cause image quality problems. Setting the
Ink Depletion for 100% is adequate for most
conditions.
18. Click the Cut Media check box if you want the printer to cut the media
after printing.
Note: Certain types of media, such as EI canvas, can not be
cut due to the thickness of the media.
19. Enter the number of seconds that the printer waits before cutting in
the Dry Time box.
20. Select the type of connection the printer has to your host computer in
the Connection Type list.