Kenwood KRF-V7773D - Manual (Page 27)

42
Using R
eceiv
er
How Do I Adjust the LCD Display?
Using Remote Control unit under low light
When using Remote Control unit under low light, the back light of the
LCD display can be turned on.
• Press and hold the F.SHIFT key for more than 2 sec-
onds.
The back light is turned on and off every 2 seconds of
holding.
If the is blinked, the back light cannot be turned on
because the batteries are nearly exhausted.
Adjusting the contrast of LCD display
The contrast of the LCD display can be adjusted to improve the visibility.
1. Press the Music key or Movie key to display “Menu”.
2. Press the Menu (LCD function key 2) key.
3. Press the Setup (LCD function key 2) key.
4. Press the LCD cursor up/down ( / ) key to select “03. Contrast”,
then press the Enter key.
5. Select the desired contrast with the LCD cursor up/down ( / )
key. The previous menu re-appears in about 3 seconds after the above
operation.
1 2 3
4 5 6
7 8 9
10 11 12
+10 0 +100
/ 8
/ 7
1 1
How Do I Adjust the LCD Display?
43
Using R
eceiv
er
Adjusting the brightness of receiver
When the ambient light is low, for example in the night, the brightness of
the receiver’s display can be dimmed and LED indicators (DTS, 96k fs,
HDCD, DOLBY DIGITAL, MPEG and D.R.I.V.E. only) can be disabled.
• Press the F.SHIFT = LISTEN M. (DIMMER)* keys. Each press of the
LISTEN M. key switches the brightness as shown below.
1 Display/bright Indicators/enabled
2 Display/dim Indicators/enabled
3 Display/dim Indicators/disabled
Selecting the display mode of receiver front panel
•
Press and hold the LISTEN MODE key on the receiver for more than
2 seconds.
The displayed information is switched every 2 seconds of holding the
key.
A: Connected Device Input Type
DVD AUTO
B: Input Terminal Connected Device
VIDEO3 : DVD
C: Listen Mode
DOLBY DIGITAL
"Input Type" is displayed only when a selector with digital input is se-
lected.
When the input mode is PHONO, TUNER or AV AUX, the connected
device and listen mode are displayed alternately.
How Do I Adjust the LCD Display?
* When an operation is described as [F.SHIFT = LISTEN M. (DIMMER)
key], for example, press the F.SHIFT key and press the next key (the LIS-
TEN M. (DIMMER) key in this case) within 8 seconds.