Kenwood Z920DVD - Manual (Page 67)

— 67 — — 67 —
Connecting Cables to Terminals
TEL MUTE
EXT.
CONT.
P.CONT
ANT.
CONT.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
PRK SW
A
B
FRONT
REAR
PRE OUT NON FADING
AUX IN
PARKING
VIDEO OUT
A
B
Front left output (White)
Front right output (Red)
Rear right output (Red)
Rear left output (White)
Battery cable (Yellow)
Ignition cable (Red)
FM/AM antenna input Antenna Cord (ISO)
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
Wiring harness
(Accessory1)
If no connections are
made, do not let the cable
come out from the tab.
NOTE
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
Power control/ Motor antenna
control cable (Blue/White)
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector B
Fuse(5A)
Connector A
TEL mute cable (Brown)
To connect the KENWOOD navigation
system, consult your navigation manual.
NOTE
External amplifier control cable
(Pink / Black)
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
To KENWOOD disc changer/ DAB control input/
KPA-SD100
To connect these leads, refer to the relevant
instruction manuals.
NOTE
AUX left input (White)
AUX right input (Red)
To KDS-P901
Non-fading right output /
Right preout (Red)
Non-fading left output /
Left preout (White)
Front left input (White)
Front right input (Red)
Rear right input (Red)
Rear left input (White)
Wiring harness
(Accessory5)
To parking brake detection
switch harness of car
For the sake of safety, be
sure to connect the parking
sensor.
2 CAUTION
To the monitor unit
Amplifier unit
Ground cable (Black) - (To car chassis)
Centre unit
Connection cable (Accessory8)
Match the cable
colours and
connect.
NOTE
Fuse(10A)
RCA cable (Accessory7)
To KDS-P901