Kenwood Z920DVD - Manual (Page 45)

— 45 —
Press the each the [ 5 or ∞ ] buttons to select the “AUDIO”.
Press the [ ENTER ] button.
Press the each the [ 5 or ∞ ] buttons to select the “D.R.C”.
Press the [ ENTER ] button.
Each time you press the [ 5 or ∞ ] buttons, the mode
switches as follows:
" FULL "
For the regular sound
" STANDARD " (Default setting)
For more powerful sound at regular volumes
" NIGHT"
For powerful sound at low volumes
3
2
1
Selecting the Dynamic Range Control (D.R.C)
Setting digital output type.
Press the each the [ 5 or ∞ ] buttons to select the “AUDIO”.
Press the [ ENTER ] button.
Press the each the [ 5 or ∞ ] buttons to select the “DIGITAL
OUT”.
Press the [ ENTER ] button.
Each time you press the [ 5 or ∞ ] buttons, the mode
switches as follows:
" STREAM " (Default setting)
Select this when connected to an amp (decoder) that supports
Dolby Digital.
" LPCM "
It’s converted to a 48 KHz/16 bit linear PCM signal and output.
Select this when connected to a device that doesn’t support
Dolby Digital.
" OFF"
Turns the digital output OFF.
Press the [ ENTER ] button. 4
3
2
1
Setting the Optical Output Mode (DIGITAL OUT)
Setting the 2x-speed Normal Sound Play function.
Press the each the [ 5 or ∞ ] buttons to select the “AUDIO”.
Press the [ ENTER ] button.
Press the each the [ 5 or ∞ ] buttons to select the “AUDIO
DURING*2”.
Press the [ ENTER ] button.
Each time you press the [ 5 or ∞ ] buttons, the mode
switches as follows:
" ON " (Default setting)
The 2x-speed Normal Sound Play function is ON.
" OFF "
The 2x-speed Normal Sound Play function is OFF.
Press the [ ENTER ] button. 4
3
2
1
Setting the Audio During 2x Search
This select can be made when the Dolby Digital signal is inputed.
Press the [ ENTER ] button. 4
NOTE