Kenwood HM-DV6MD - Manual (Page 23)

23
Basic use method
Basic section
Muting the sound temporarily
÷ Press again to resume the original volume.
÷ This is also cancelled when the volume is changed.
Bass and treble compensation
(NB : Natural Bass circuit)
Each press switch the modes as follows.
1 "NB 1" (Only the lowest frequencies
are enhanced.)
2 "NB 2" (The lowest and highest
frequencies are enhanced according
to the current volume level.)
3 "NB OFF" (The source signal is pro-
cessed by the tone control circuitry be-
fore being output from the main unit.)
Tone adjustment
÷ The "BASS" and "TREBLE" can be adjusted inde-
pendently in the range from "- 8" to "+ 8".
1
Press the TONE key to select "BASS".
Adjust the level of lowest frequencies as de-
sired using the VOLUME keys.
2
Press the TONE key again while "BASS" is
displayed to select "TREBLE".
Adjust the level of the highest frequencies
using the VOLUME keys.
3
Press the TONE key.
MUTE
SOUND
The responses of the lowest frequencies (BASS)
and highest frequencies (TREBLE) can be ad-
justed as desired.After this adjustment, the N.B.
effect will be disabled.
TONE
∞ 5
VOLUME
\
Balance adjustment
The balance of volumes from the left and right
speakers can be adjusted as follows.
1
Press the MODE key.
2
Turn the VOLUME/MULTI CONTROL knob
to select "BALANCE", then press the SET/
DEMO key.
3
Adjust the left and right speaker balance by
turning the VOLUME/MULTI CONTROL
knob.
4
Press the SET/DEMO key.
- - - - L - R
URROUND
P.S.A.
NB
MHz
kHz
1 2
E B T L E R + 4
MUTE
Remote control unit only
Remote control unit only
Blinks