beautypg.com

Materials and basic tools needed, Materials needed, Basic tools – Kenmore Power Miser 9 Gas Water Heater 153.33096 User Manual

Page 6: Additional tools needed when sweat soldering

background image

6

MATERIALS AND BASIC TOOLS NEEDED

Materials Needed

To simplify the installation, Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.

WATER HEATER INSTALLATION KIT WITH
FLEXIBLE CONNECTORS FOR 3/4”
(19.05 mm) OR 1/2” (12.7 mm) THREADED OR
COPPER PLUMBING AND FLEXIBLE WATER
HEATER GAS CONNECTOR WITH FITTINGS.

EXPANSION TANKS FOR
THERMAL EXPANSION
CONDITIONS AVAILABLE
IN 2 GALLONS
(7.6 LITERS) AND
5 GALLONS (18.9 LITERS)
CAPACITY THROUGH
LOCAL SEARS STORE
OR SERVICE CENTER.

DRAIN PANS AVAILABLE IN
20” (508 mm) DIAMETER FOR
WATER HEATERS HAVING A
DIAMETER 18” (457 mm) OR
LESS, 24” (610mm) DIAMETER
FOR WATER HEATERS HAVING
A DIAMETER 22” (559 mm)
OR LESS AND AVAILABLE IN
28” (711 mm) DIAMETER FOR
WATER HEATERS HAVING A
DIAMETER 26” (660 mm) OR
LESS.

Basic Tools

You may or may not need all these tools, depending on your
type of installation. These tools can be purchased at your local
Sears Store.

• Pipe Wrenches (2) 14” (356 mm)
• Screwdriver
• Tin Snips
• 6’ (1.82 m) Tape or Folding Ruler
• Garden Hose
• Drill
• Pipe Dope or Tefl on Tape

Additional Tools Needed
When Sweat Soldering

• Tubing Cutters or Hacksaw
• Propane Tank
• Soft Solder
• Solder Flux
• Emery Cloth
• Wire Brushes

SLOT-HEAD SCREWDRIVER

PHILLIPS SCREWDRIVER

TIN SNIPS

PIPE WRENCH

PIPE DOPE

(SQUEEZE TUBE)

USE FOR WATER AND GAS

CONNECTIONS

DRILL

GARDEN HOSE

6 FOOT TAPE

ROLL OF TEFLON

TAPE (USE ONLY ON

WATER CONNECTIONS)

HACKSAW

3/4” (19 mm) WIRE BRUSH

1/2” (13 mm) WIRE BRUSH

SOLDER

FLUX

ROLL OF LEAD-FREE

SOFT SOLDER

TUBING CUTTER

PROPANE

TORCH

ROLL OF

EMERY CLOTH

This manual is related to the following products: