beautypg.com

Temperature-pressure relief valve operation, Draining, Drain valve washer replacement – Kenmore Power Miser 9 Gas Water Heater 153.33096 User Manual

Page 25: Service

background image

25

Temperature-Pressure Relief Valve Operation

The temperature-pressure relief valve must be manually operated
at least once a year.

When checking the temperature-pressure relief valve operation,
make sure that (1) no one is in front of or around the outlet of
the temperature-pressure relief valve discharge line, and (2) that
the water discharge will not cause any property damage, as the
water may be extremely hot, see Figure 32.

FIGURE 32.

If after manually operating the valve, it fails to completely reset
and continues to release water, immediately close the cold water
inlet to the water heater, follow the draining instructions, and
replace the temperature-pressure relief valve with a new one.

If the temperature-pressure relief valve on the appliance weeps
or discharges periodically, this may be due to thermal expansion.
You may have a check valve installed in the water line or a water
meter with a check valve. Consult the Sears Service Center
for further information. Do not plug the temperature-pressure
relief valve.

Draining

The water heater should be drained if being shut down during

freezing temperatures. Also periodic draining and cleaning of

sediment from the tank may be necessary.

1. Turn the gas control knob to the “OFF” position.

2. CLOSE the cold water inlet valve to the water heater.

3. OPEN a nearby hot water faucet and leave open to allow for

draining.

4. Connect a hose to the drain valve and terminate to an

adequate drain.

5. OPEN the water heater drain valve to allow for tank

draining.

NOTE: If the water heater is going to be shut down and
drained for an extended period, the drain valve should be
left open with hose connected allowing water to terminate
to an adequate drain.

6. Close the drain valve.

7. Follow the lighting instructions in the Lighting section to restart

the water heater.

Drain Valve Washer Replacement

(See Figure 33)

1. Turn “OFF” gas supply to water heater.

2. Follow “Draining” instructions.

3. Turning counter clockwise (

), remove the cap.

4. Unscrew the stem by turning it counter clockwise (

), and

remove it from the drain valve body.

5. Remove the bottom washer and put the new one in place.

6. Re-insert the stem into the drain valve body and retighten the

cap to the body using a wrench. DO NOT OVER TIGHTEN.

7. Follow instructions in the Filling The Water Heater section.

8. Check for leaks.

9. Follow the lighting instructions in the Lighting section to restart

the water heater.

WASHER

WASHER

CAP

STEM

FIGURE 33.

Service

Before calling for repair service, read the Start Up Conditions
and Operational Conditions found in the Troubleshooting Guide
of this manual.

If a condition persists or you are uncertain about the operation of
the water heater, let the Sears Service Center check it out.

Contact Sears Service Center at:

1-800-4-MY-HOME

®

(1-800-469-4663).

This manual is related to the following products: