Konica Minolta xg - Manual (Page 94)

94 SETUP MODE
To make a custom recording, select either focus signal or shutter
FX from the Cust. FX rec. option on the setup menu. Messages
will appear during the routine.
Custom FX recording
A personalized sound effect can be recorded for the focus signal and shutter release. The camera
uses an audio signal to indicate the camera has focused.
Audio signals
Shutter FX
CustomRecord
Volume
Power off
Focus signal
Shutter FX
3 min.
Press the shutter-release button to begin the recording of the
shutter sound effect.
Press shutter button
to record.
Microphone
Recording audio.
Press shutter to stop.
Remaining recording time
During the recording, hold the camera’s microphone
approximately 20cm (8 in.) from the audio source. Up to
four seconds of audio can be recorded. The remaining
recording time is indicated by a status bar and the frame
counter on the monitor. The recording will end when the
shutter-release button is pressed again or recording time
has elapsed.
The length of the recording will affect the performance of
the camera. The longer the recorded sound effect, the
longer the delay between image capture. This can have a
significant affect on the continuous-advance frame rate.