Kenwood DMF-5020 - Manual (Page 8)

DMF-5020/DMF3020/MD-203 (En)
8
Safety Precautions
Do not touch the disc directly.
Do not touch the disc by opening the shutter with your hand. The
cartridge will be damaged if it is forced open.
Handling of Mini Disc
As the Mini Disc is accommodated inside a cartridge, it can be handled
without caring about dust or fingerprint. However, stained or soiled
cartridge may cause malfunction. To enjoy beautiful sound for ex-
tended period of time, take care on the following points.
Care
Wipe periodically dust and dirt attached on the cartridge with a dry
cloth.
Write protect tab
To protect recorded contents against accidental erasure, set the write
protect tab of the disc open. Return the tab to the original position
when you want to record signals on the disc.
Before transporting or moving this unit, carry out the
following operations.
1. Set the POWER key to ON without loading a Mini Disc.
÷ Check that no disc is present in the unit.
2. Wait a few seconds and verify that the display shown
appears.
3. Set the POWER key to OFF.
Storage position
Do not leave Mini Discs in place where the temperature and/or
humidity are extremely high (for example, in a place subject to direct
sunlight).
Slide close.
(Recording enabled) Slide open.
(Recording disabled)
Disc back side
Installation position
The MD recorder is very sensitive to vibrations. It should be installed
in a position subject to as small vibration as possible.
Dust countermeasure
The shutter of the disc cartridge is permanently open while the disc
is loaded in the set. Therefore, to prevent dust from penetrating inside
the disc, take the disc out of the unit immediately after completion of
recording or playback.
Information that you should know
Note related to transportation and movement
N O D I S C
SEARCH PGM
MONITOR
ANALOG
32kHz
2 1 3
48kHz
44.1kHz
DIGITAL
Write protect tab