Kenwood XD-351 - Manual (Page 8)

8
XD SERIES (En)
Preparation
System connection
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around
the unit (from the largest outer dimensions including projec-
tions) equal to, or greater than, shown below.
Rear panel: 10 cm
AM loop antenna connection
The supplied antenna is for
indoor use. Place it as far as
possible from the main sys-
tem, TV set, speaker cords
and power cord, and set it to
a direction which provides
the best reception.
FM indoor antenna connection
The accessory antenna is for
temporary indoor use only.
For stable signal reception
we recommend using an
outdoor antenna. Remove
the indoor antenna if you
connect one outdoors.
• Never short-circuit the + and –
speaker cords.
• If the left and right speakers are
connected inversely or if the
speaker cords are connected with
reversed polarity, the sound be-
comes unnatural with ambiguous
acoustic image positioning. Be
sure to connect the speakers and
speaker cords correctly.
Note Note
1 2 3
AM loop antenna connection
FM antenna connection
AUX INPUT
1
2 BEAT CANCEL
R
L
–
+
+
–
SPEAKERS (6–16 Ω )
FM 75 Ω AM
ANTENNA
GND AC 220 –240V AC 110 –120V
SUPER WOOFER
PRE OUT
FM 75 Ω AM
ANTENNA
GND
FM 75 Ω AM
ANTENNA
GND
R L
Europe and U.K.
Other countries
R L
AUX INPUT
1
2 BEAT CANCEL
R
L
–
+
+
–
SPEAKERS (6–16 Ω )
FM 75 Ω AM
ANTENNA
GND AC 220 –240V AC 110 –120V
R L
AUX INPUT
1 2 BEAT CANCEL
R
L
–
+
+
–
SPEAKERS (6–16 Ω )
FM 75 Ω AM
ANTENNA
GND AC 220 –240V AC 110 –120V
FM 75 Ω AM
ANTENNA
GND
FM 75 Ω AM
ANTENNA
GND
Europe and U.K.
Other countries
FM 75 Ω AM
ANTENNA
GND
FM 75 Ω AM
ANTENNA
GND
Europe and U.K.
Other countries
10mm 10mm
1 Strip the coating from the tip of cord
and twist the conductor.
2 Connect to the antenna terminal.
3 Locate the position providing good
reception condition.
4 Fix the antenna.
FM outdoor antenna
Lead the 75W coaxial
cable connected to the FM
outdoor antenna into the
room and connect it to the
FM 75W termimal.
Antenna adapter
(optional)