Kenwood TM-455E - Manual (Page 85)

9 MCP-2A Memory Control Program (for use with TM-V71A/E, TM-D710A/E, RC-D710)
TM-D710A/E CONTENTS 75
9.5.3 Menu Settings
9.5.3.1 Transceiver Menu > EchoLink RX Monitor
When using the transceiver in EchoLink Sysop mode, output from the speaker and output to the
data terminal can be configured. This function is only possible to configure with the MCP-2A.
9.5.3.2 Transceiver Menu > Repeater Mode (K-type only)
It is possible to configure the transceiver as a cross-band repeater. When the transceiver is
configured to be a repeater, there is a function that transmits the repeater’s own ID. You can
configure the ID transmission method and choose between Off, Morse code or Voice. When
Voice is selected, it is necessary to install the optional VGS-1 Voice Guidance and Storage unit.
The combined use of cross-band repeater with the external remote function is not possible. The
cross-band repeater function is only available on a K-type (U.S.A. and Canada) model.
9.5.3.3 Transceiver Menu > Password
It is possible to configure the character string for the password. This function is only possible to
configure with the MCP-2A.
9.5.3.4 Transceiver Menu > 10MHz Mode
Configure whether you will use the 10 MHz step variable function.
9.5.3.5 Transceiver Menu > TM-D710A/E
This item can only be configured with TM-D710A/E.
9.5.3.6 Transceiver Menu > RC-D710
This item can only be configured with RC-D710.
9.5.3.7 Transceiver Menu > Variable Level of Data Terminal
It is possible to configure the input sensitivity of the external equipment terminal for data
communications and the output level. The settings are differentiated between TM-V71A/E,
TM-D710A/E and RC-D710.
9.5.3.8 Transceiver Menu > SQC Output Logic
It is possible to configure the output logic of the external output terminal (active level) that is used
for data communications, etc. Normally, EchoLink Sysop mode uses the “High” configuration.
For details, refer to 8.5.4 Using MCP-2A to Connect TM-D710A/E.