Kenwood TM-455E - Manual (Page 80)

9 MCP-2A Memory Control Program (for use with TM-V71A/E, TM-D710A/E, RC-D710)
70 CONTENTS TM-D710A/E
6. Finish the installation. The fact that
information is read from the target
transceiver completes the MCP-2A
installation.
Click the “OK” button, select “Read Data
from the Transceiver” from the Program
pulldown menu and read the information
from the target transceiver.
Note: The basic method of using MCP-2A is to read
the existing transceiver data into MCP-2A, edit
the configuration, and then write the new
configuration back to the transceiver.
Figure 9-5 MCP-2A Read Transceiver
Advisory Message
Figure 9-6 MCP-2A Program Menu:
Read Data from the Transceiver