Help – Kenwood ADVANCED INTEGRATION A/V CONTROLLER KOS-V500 User Manual
Page 78

78 KOS-V500
Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
▲
Subwoofer is not set to On.
☞
(page 58)
▲
The Dual zone function is enabled.
☞
Control> (page 76) ! Cannot set up the subwoofer phase. ▲ Subwoofer is not set to On. ☞ (page 58) ▲ Low pass filter is set to Through. ☞ Network Setup> (page 59) ! • Cannot select the output destination of the subsource in the Dual zone. • Cannot adjust the volume of the rear speakers. ▲ The Dual zone function is disabled. ☞ Control> (page 76) ! Cannot Folder select. ▲ The Scan play or Random play function is enabled. ! • The Traffic Information setting is ineffective. • The Synchronize Clock setting is ineffective. • Cannot select the tuner as a Dual zone source. ▲ HD Radio is in use. ▲ Tuner souce function is disabled. ☞ Setup> (page 60) ! • Cannot set up the equalizer. • Cannot set up the crossover network. ▲ The Dual zone function is enabled. ☞ Control> (page 76) What might seem to be a malfunction in your unit General ? The Touch Sensor Tone doesn’t sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can’t be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on Audio file source ? The sound skips when an Audio file is being played. ✔ The recording condition is bad. ☞ Record the media again or use another media.
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.