Kenwood ADVANCED INTEGRATION A/V CONTROLLER KOS-V500 - Manual (Page 72)

72 KOS-V500
EXT SW Setup
Setting up power specification of the external
device for which the power is controlled from
this unit.
1 Display the EXT SW SETUP screen
Touch [Ext SW SETUP] in the SETUP Menu
(page 58).
2 Perform EXT SW Setup
Setting EXT SW Control 1 (EXT SW1)
1
2
3
4
1 Sets the name of the external device. See
(page 48) for information
on how to enter the name.
2 Sets the power signal output mode.
( EXT SW1: Pulse, EXT SW2: Level)
Pulse: Generates a single power signal
pulse.
Level: Continues output of high power
signal.
Sets to turn output on/off each time the
button on the EXT SW Control screen is
pressed.
3 Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases
by 200ms with each step. Up to 100 steps
can be set.
4 Returns to the original screen.
Setting EXT SW Control 2 (EXT SW2)
1
2
3
4
The setup method is the same as "EXT SW1".
Setup Menu