Kodak ESP 9 - Manual (Page 129)

www.kodak.com/go/aiosupport 121
Kodak ESP 9 All-in-One printer
FCC and Industry Canada
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
This device has been designed to operate with an antenna having a maximum gain
of 1.8dB.
Antenna having a higher gain is strictly prohibited per regulations of Industry
Canada. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the EIRP is not more than required for successful
communication.
IC Radiation Exposure Statement
IMPORTANT NOTE: This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20 cm between the radiator and your body.
Canadian DOC Statement
DOC Class B Compliance—This Class B digital apparatus complies with Canadian
ICES-003.
Observation des normes-Class B—Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
European Compliance Statement
Hereby, Eastman Kodak Company declares that this KODAK all-in-one wireless
printer is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
German Compliance Statement
Noise emissions for this equipment do not exceed 70 dB(A).
This equipment is not intended for use in the work place in accordance with
BildscharbV regulations.
“Das Gerät ist nicht für die Benutzung am Bildschirmarbeitsplatz gemäß
BildscharbV vorgesehen.”