Kodak 6J7611A - Manual (Page 18)

3-2 A-61500 May 2010
Manually pausing
and resuming the
scanner While scanning documents:
• Press the Stop/Pause button on the scanner once to pause
scanning.
NOTE: Your application may configure the scanner with a transport
timeout function which signals an End of Job. If you do not start/
resume scanning before the timeout expires, you cannot
continue scanning without restarting the job from the host
application.
• Press the Start/Resume button on the scanner to restart scanning
after it has been paused.
Automatically
pausing and
resuming the
scanner During scanning the scanner monitors its own internal image buffer
memory. In order to prevent overwriting images before the host
computer can retrieve them, the scanner will automatically pause the
feeder while waiting for the host computer to read existing images.
The scanner automatically resumes scanning by restarting the feeder
once image buffer memory is cleared. To avoid this situation be sure
your host computer meets the minimum system requirements as
referred to in Chapter 2.
Manually ending
scanning After feeding the last document to be scanned, you can end scanning
by pressing the Stop/Pause button on the scanner twice. An end of job
message will be sent to your host application.
You cannot continue scanning without restarting the job from the host
application.
Start/Resume
Stop/Pause
button
button