beautypg.com

3 using the scanner, Turning the scanner on and off, Starting and stopping scanning – Kodak 6J7611A User Manual

Page 17

background image

A-61500 May 2010

3-1

3 Using the Scanner

This chapter provides the following operational procedures:

• Turning on/off the scanner

• Starting, stopping, pausing and resuming the scanner

• Document preparation

• Adjusting the side guides and output tray

• Scanning documents

• Feeding long documents

• Automatic, continuous and manual feeding

• Calibration

Turning the scanner
on and off

• Press the button on the scanner’s lower right-side (I) to power it up.

• Press the button on the scanner’s lower right-side (O) to power it

down.

After you power up the scanner, wait until for it to complete self-test.
When completed, the top green indicator light will remain on and
constant. If this does not occur, refer to Chapter 6, “Indicator lights” for
more information.

IMPORTANT: Always power up the scanner to its ready state before

powering up or restarting the host computer.

Starting and stopping
scanning

Scanning is controlled by integration software developed for your
application. To start and stop scanning, refer to the documentation
provided with your integration software.

If your application does not automatically start the scanner transport,
begin the scanning process by pressing the Start/Resume button on
the scanner.

NOTE: Before you start scanning, make sure the scanner is ready for

operation, which is indicated by the top green indicator light
being on and constant.