Kodak 6J7611A - Manual (Page 13)

A-61500 May 2010 2-3
Attaching the power cord The Kodak i600/i700 Series Scanner is packed with a set of power
cords.
1. Select the power cord which complies with your electrical
requirements and attach it.
2. Turn on the scanner and wait until the top green LED is lit indicating
the scanner has completed power-up self-test and is idle.
Powering up the host
computer • Turn the power on to the host computer.
Scanner components Front view
1 Elevator tray extender — open the elevator tray extender to
accommodate long documents.
2 Feed module — provides smooth document feeding of various
sizes, thicknesses and textures.
CAUTION:Moving parts, avoid contact.
3 Elevator tray side guides — slide the guides in or out to
accommodate the document size you want to scan. Side guides
can be left-, center- and right-adjusted to accommodate
documents of various widths. The side guides can also be locked
into position if desired.
4 Gap release lever — allows you to manually adjust the space
between the feed module and separation roller for documents that
require special handling.
5 Output tray and end stop — collects the scanned documents.
The output tray width and end stop length can be adjusted.
6 POD release latch — push up the POD release latch when you
need to access the inside of the scanner.
1
11 2
3
4
5
10
7
6
8
9
12*