Using setups on more than one camera, Using setups on more than one camera -16 – Kodak DCS Pro SLR/n User Manual
Page 80
5-16
April 29, 2004
Configuring your Camera
Using Setups on More
than One Camera
Most settings are transferred when you load User Setups that have been
saved to a card using a different DCS Pro SLR/n camera. The exceptions are
Click Balance and Job Tracker settings, but you can work around these
exceptions.
Before saving a User Setup on one camera and loading it on another:
1. Set up Click Balance identically on both cameras.
a. Capture the same image using both cameras, then perform the
same Click Balance on both images (see
).
b.Save the Click Balance setting (see
). The settings must
have the same names on both cameras.
c. Repeat for all need Click Balance settings.
2. Load identical Job Tracker files into the memory of both cameras (see
). The settings must have the same names on both cameras.
NOTE: If the Job Tracker file named in the User Setup is no longer in
camera memory, Job Tracker will be disabled.