KORG EMX-1 - Manual (Page 88)

88
Error messages
If an error message is displayed, you can clear it by press-
ing the STOP/CANCEL key.
Card Fmt
The SmartMedia™ could not be read.
➝ Use your computer or other device to back up the
data on the SmartMedia™ card. Then format the
SmartMedia™ on the EMX-1, rewrite the desired
files to it, and access it once again from the EMX-1.
CardFull
There is insufficient free space in the EMX-1 or on
SmartMedia™.
➝ If you want to save data, you must delete unneeded
files from the SmartMedia™ card to create suffi-
cient free space. Then write or save the data. The
SmartMedia™
must have a minimum of approxi-
mately 2 MB of free space in order to save EMX-1
data.
EventOvr
You have exceeded the maximum number of events that can
be recorded in a song.
➝ Delete unneeded song event data.
FileDelt
An error occurred while deleting a file from SmartMedia.
➝ Try the operation once again.
FileLoad
An error occurred while loading a file from SmartMedia™.
➝ Try the operation once again.
FileName
When saving to SmartMedia, an identically-named folder
already exists.
➝ Either use your computer to delete the folder from
the SmartMedia, or change the filename on the
EMX-1 and save it again.
FileSave
An error occurred while saving to SmartMedia™.
➝ Try the operation once again.
MotSqFul
The motion sequence cannot be recorded.
➝ On the EMX-1, you can record a maximum of 24
motion sequences for each pattern.
Use CLEAR MOTION (☞p.61) to delete unneeded
motion sequences, and then input your data once
again.
NoFiles
The SmartMedia™ does not contain any files that the EMX-
1 can recognize.
➝ The EMX-1 can load only .EMX files.
Protect
You attempted to write the data into memory when the data
protect setting was turned on.
➝ In Global mode, turn memory protect off.
If the write protect label is affixed to the
SmartMedia™, remove it.
SongEvnt
While writing a song to a different-numbered song, you
exceeded the maximum number of events that can be re-
corded.
➝ Delete unneeded event data to free up more
memory space.
Write
The data could not be written.
➝ Try the writing operation once again.