KORG EMX-1 - Manual (Page 56)

56
Copying a part
COPY PART .............................................................................
Here’s how you can copy the selected part (with its sound settings
and sequence data, including motion sequence) to another part.
1. If the EMX-1 is playing, press the STOP/CANCEL key to stop play-
back.
2. Press a part key to select a destination (copy-destination) for the
part being copied (the key will light).
3. Hold down the SHIFT key and press step key 4 (Copy Part). (Key 4
will blink.) The copy-destination part key will begin blinking.
4. Use the dial to select the pattern number of the part to be copied
(copy-source).
5. Press a part key to select the copy-source part. (The copy-source key
will blink, and the copy-destination key will go dark.) You can hear
the sound of the copy-source by pressing its part key. (Synth parts
will sound at C4.)
6. Press step key 4 once again to execute the Copy Part operation. If
you decide to cancel, press the STOP/CANCEL key.
When you copy between parts, only the trigger data is copied.
If the copy operation would result in there being more than 24 mo-
tion sequences, the motion sequences will not be copied.
Copying only the sound of a part
COPY SOUND ........................................................................
Here’s how you can copy only the sound settings of another part to
the selected part. Step data and motion sequence data will not be
copied.
1. If the EMX-1 is playing, press the STOP/CANCEL key to stop play-
back.
2. Press a part key to select a destination (copy-destination) for the
part being copied (the key will light).
3. Hold down the SHIFT key and press step key 5 (COPY SOUND).
(Key 5 will blink.) The copy-destination part key will begin blink-
ing.
4. Use the dial to select the pattern number of the part to be copied
(copy-source). You can press the SHIFT key to view the pattern name
of the copy-destination.
5. Press a part key to select the copy-source part. (The copy-source key
will blink, and the copy-destination key will go dark.) You can hear
the sound of the copy-source by pressing its part key. (Synth parts
will sound at C4.)
6. Press step key 5 once again to execute the Copy Sound operation. If
you decide to cancel, press the STOP/CANCEL key.
You cannot copy sound data between a synth part and a drum part.
Erasing the sequence data of a part
To erase sequence data from the selected part, you can use the sixteen step keys
to turn each trigger on/off independently, or use one of the following two operations.
To erase all of a part's performance data
CLEAR PART ............................................................................
This operation erases the rhythm or phrase pattern (trigger, note
number, gate time) and motion sequence data at once.
3
3
3
3