Playing a motion sequence, Checking motion sequence data, Will light – KORG EMX-1 User Manual
Page 59: 59 4. pattern mode
59
4. Pattern mode
If you press the STOP/CANCEL key to stop playback and then save
the pattern as described in “Saving a pattern,” the motion sequence
data you recorded will be saved together with the pattern.
You can record a maximum of twenty-four motion sequences in each
pattern.
Playing a motion sequence
You can play back a motion sequence in one of the two modes described below.
The playback mode can be selected independently for each part.
Effect motion sequences will always play back using the SMOOTH mode of a part
motion sequence. Motion sequences for an accent part will always play back using
the TRIG HOLD mode.
AMP EG, ROLL, FX SELECT, FX SEND, MOD TYPE, MOD DEST,
BPM SYNC, and SYNTH FILTER TYPE motion sequences will al-
ways play back using TRIG HOLD even if SMOOTH is selected.
SMOOTH:
Knob movements will be played back smoothly, you will
here the effect of the knob being turned even as a single note
is sustained.
TRIG HOLD (trigger hold):
Each new note being triggered will “hold”
the motion sequence knob value as it was when the note
was first triggered.
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16
On
On
On On
On On
On
On
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16
On
On
On On
On On
On
On
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16
On
On
On On
On On
On
On
Playback the motion sequence
with Trig Hold setting
Knob movements when the motion
sequence was recorded
Playback the motion sequence
with Smooth setting
If the motion sequence LED is dark (off), this setting does nothing.
Checking motion sequence data
Here's how you can check and see what type of motion sequence data has been
recorded. Hold down the shift key and press the motion sequence key of the part
common section, and the step keys will light to indicate the motion sequence data
that has been recorded. The display will indicate “FreeMot” and the number of
remaining motion sequences that you can still record.
If a motion sequence is recorded for
The following key will light
Part Common section knobs
Step keys 1 and 2
Synth Filter section
Step key 3
Part Common section keys
Step key 4
Effect 1 motion sequence (Fx Edit 1 data)
Step key 5
Effect 1 motion sequence (Fx Edit 2 data)
Step key 6
Effect 2 motion sequence (Fx Edit 1 data)
Step key 7
Effect 2 motion sequence (Fx Edit 2 data)
Step key 8
Effect 3 motion sequence (Fx Edit 1 data)
Step key 9
Effect 3 motion sequence (Fx Edit 2 data)
Step key 10
Modulation knobs
Step key 11
Modulation keys
Step key 12
Synth oscillator OSC Edit 1
Step key 13
Synth oscillator OSC Edit 2
Step key 14
You cannot check the motion sequence data during playback or re-
cording, or while playing a pattern set.