Kenwood XD-A900 - Manual (Page 24)

XD-951/A900/A700 (En)
24
Preparation section
Basic section
Application section
Knowledge sections
Relay play
When tapes are set in the decks A and B and the reverse mode is
set to “
[” (play of both sides), play of the second deck will be
started automatically after play of the first deck has been com-
pleted. Tape play will be repeated alternately.
A tip for use of the tape counter
The tape counter is set to “0000” when a cassette tape is loaded.
By writing down the counter reading in case you want to inter-
rupt recording (playback) in the middle of the tape, the memo
will be helpful as a reference for locating the same position when
continuing the recording (playback) the next time. The tape coun-
ter figure decrements during recording or playback of the back
side (while the
2 tape transport indicator is lit).
To set the tape counter to “0000”, open the cassette holder once.
Then the counter will be reset.
Let's put out some sound
÷ Relay play is not possible in the reverse modes “”” and ““”.
A A
NR
B 00 0 0 E P A T