Kenwood XD-A900 - Manual (Page 16)

XD-951/A900/A700 (En)
16
Preparation section
Basic section
Application section
Knowledge sections
1Turn power off.
2Select the channel space.
Each press switches the space frequency alternately.
1 “FM100/AM10 kHz” ....... STEP,
2 “FM 50 /AM 9 kHz” ....... STEP,
÷ The “AM” display is variable depending on the model (country or
area), and “MW” may be displayed in some areas.
3Establish the selection.
Operation
Plug the power cord into the mains power outlet and press
the on/standby (
POWER) key of the remote control
unit to turn power ON. After the power has been turned
ON, press the desired key.
To turn power off, press the on/standby ( POWER)
key again. The system enters the standby mode in which
only the time display is lit.
÷When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Loading batteries
2 Insert batteries. 3 Close the cover.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
1 Remove the cover.
Operation of remote control unit
Notes Notes
Operating range
(approx.)
Remote sensor
÷ Insert two R6 (“AA”-size) batteries following
the polarity indications.
TUNING
CHANNEL SPACE setting
(Except for the U.S.A., Canada, U.K., Europe, Russia and Australia)
CHANNEL
SPACE freq.
Area
1
2
U.S.A., Canada and South
American countries
Other countries
FM : 100 kHz
AM : 10 kHz
FM : 50 kHz
AM :
9 kHz
The space between radio channels has been set to the one that pre-
vails in the area to which the system is shipped. However, if the
current channel space setting does not match the setting in the area
where the system is to be used, for instance when you move from
area 1 or area 2 shown in the following table or vice versa, proper
reception of AM/FM (MW/FM) broadcasts cannot be expected. In
this case, change the channel space setting in accordance with your
area by referring to the following table.
ON/STANDBY
0/ AM 1 0 0 1 M F
0/ AM 9 5 M F
ENTER
30˚
6m
30˚