KORG SP-500 - Manual (Page 35)

35
Playing the SP-500
4 Press the “Copy” button
The “Custom Copy” page will appear.
5 Select the program that you wish
to copy
Press the “Source Prog” cell, and select
the program you wish to copy to the pro-
gram that was selected in step 2. Use the
same procedure as usual when selecting a
program. (☞p.24) After making your
selection, press the [EXIT] switch to
return to the previous screen.
6 Press the “Copy” button
The program will be copied, and you will
return to the “Custom Prog” page.
To change the program name
If you wish to change the name of the
program, press the “Rename” button
before you write, and change the name.
☞“Changing the program name”
7 Write the program
If this is the program you want, press the
“Write” button to write it.
Never turn off the power while data is being
written.
If you decide not to write
Press the “Cancel” button without writ-
ing, the copied contents will be dis-
carded, and the data will revert to the
original program. You will return to the
main page.
8 Change other programs as well
Repeat steps 1–7 to collect the desired
programs in the [USER] program group.
Restoring the factory-set condition
Press the “Preset” button. When the con-
firmation message appears, press “OK.”
When you restore the factory-set data, the entire
[USER] program contents will be lost.
Changing the program name
You can modify the name of a program that you
“Write” to the [USER] program group. Press the
“Rename” button and modify the filename.
1 Access the “Rename” button
Press the “Rename” button, and the
“Rename” page will appear.
2 Select a character
Use the dial or the [VALUE] switches to
select the first characters.
3 Finalize the first character
Press the “Set” button to finalize the first
character.
4 Select the next character
Select characters as in steps 2 and 3 to
assign the desired file name.
A file name of up to 16 characters can be
assigned.
To make a correction
Use the “o,” “k” button to move the
cursor to the character that you wish to
correct.
If you wish to delete the character, press
the “Delete” button; the character at the
cursor location will be deleted. If you
wish to insert a character, press the
“Insert” button; the selected character
will be inserted at the cursor location.
5 Finalize the program name
After you have input the entire program
name, press the “Return” button.
To save the program name, you must per-
form the “Write” operation. ☞Refer to
step 7 of “Collecting favorite sounds into
a [USER] program group.”