Kyocera WP31C - Manual (Page 193)

A.3 General Description of Options
A-12
A.3.8 Hard Disk
The hard disk is used for saving print data. This is advantageous when printing multiple sets
of copies, as high-speed printing is possible using the electronic sorting function. The hard
disk is further required in order to use the e-MPS function. You can use the KM-NET
Printer Disk Manager utility to keep track of the stored data. This software is included in
the CD-ROM supplied with the printer.
The hard disk is installed in the HDD (upper) slot provided for it at the back of the printer as
shown below.
The hard disk must be formatted before the initial use. To format the hard disk, use the
printer operator panel or the KM-NET Printer Disk Manager. Before you install the hard
disk in the printer, power off the printer and unplug the power cord.
Figure A-15
Caution
• Do not install the hard disk in the OPT (lower) slot.
• This printer remains energized for 30 minutes even after it is powered off
for internal cooling. Unplug the power cord before installing the hard disk
in the printer. Power on the printer immediately after you finish the hard
disk installation.
HDD Slot