Sharp VC-MH715HM - Manual (Page 40)

36
www.sharp.co.uk/support
MORE INFORMATION ABOUT YOUR VCR
TROUBLESHOOTING
AREA PROBLEM POSSIBLE CAUSE/CURE
RECORDING The VIDEO Plus+
system does not
record desired
programme.
(VC-MH715HM
only)
• Ensure date and time are correctly set on the
VCR.
TAPE
TRANSPORT/
MECHANISM
Tape can not be
loaded. • Make sure there is no other tape in the VCR.
• Make sure you are loading the tape
correctly.
Rewind is not
possible.
• Make sure the tape is not at the start.
REMOTE
CONTROL
The VCR can not be
operated by remote
control. • Remote control is too far away from the main
unit.
• Point the remote control at the VCR.
• Batteries are flat - replace both.
• Batteries have not been inserted correctly.
• VCR is positioned in strong light.
OTHER
PROBLEMS
Picture does not
change even though
the VCR CHANNEL
/ buttons are
pressed.
• Make sure the VCR is not in Timer or Menu
mode.
Desired channel
position can not be
selected. • The channel position has been set to be
skipped. Cancel the SKIP mode for that
channel.
No colour or poor TV
picture on normal
viewing. • Make sure all the cables are connected
properly.
• Make sure the VCR power cord is properly
plugged in.
Not possible to view
picture or playback
through AERIAL OUT. • Make sure the RF OUTPUT has not been
switched off. (Refer to page 37, RF CHANNEL
TUNING and RF THROUGH ON/OFF)
Desired channel has
interference. • Possible weak signal strength, the same
channel with a better signal strength may
have been tuned in on another VCR preset
channel. Example;
VCR preset 1 = BBC1 and
VCR preset 14 = BBC1
(Refer to Manually Sorting Channels section
to move the channel to your desired
position.)
• TV aerial may need adjusting.
No picture appears. • Make sure the TV is on the video channel.
• Check all connecting cables.
TINS-A079UMN1.book Page 36 Monday, November 4, 2002 1:01 PM