Sharp VC-MH715HM - Manual (Page 16)

12
www.sharp.co.uk/support
BASIC OPERATION
IMMEDIATE RECORDING CONTINUED
TAPE SPEED SELECTION
Your VCR has three tape speeds: SP (Standard Play) , LP
(Long Play) and EP (Extended Play).
Press the TAPE SPEED button on the remote
control to select the desired setting.
It is recommended that EP recordings are only played back on the VCR on which they were
originally recorded.
You can record the channel you are watching or a different channel.
1. Insert a video tape into your VCR.
2. Select the channel you wish to record on the VCR as
above.
3. To start recording, press REC .
4. To pause during recording, press PAUSE/STILL .
5. To continue recording, press REC .
6. To stop recording, press STOP once.
SIMPLE TIMED RECORDING:
1. Press REC .
2. To specify a stop time, each additional press of
REC will delay the stop time by 10
minutes.
3. To stop recording at any time, press
STOP once.
NOTES:
• If the tape ends before the recording is complete the VCR will stop recording, rewind,
eject the tape and place the VCR into STANDBY mode, or just eject the tape and place
the VCR in STANDBY timer mode if the VCR is in timer record mode.
• If the VCR ejects the video tape when you press REC the tape is record protected.
i.e. record protection tab has been removed.
Cassette
Length Recording
Time
E-240 In Minutes
S P 240
L P 480
E P 720
DPSS
SLOW
TAPE
SPEED
REC PAUSE/STILL
REW FF
PLAY / X2
STOP
0
STOP 15:30
REMOTE CONTROL
TINS-A079UMN1.book Page 12 Monday, November 4, 2002 1:01 PM