How to use the video plus, System to make a recording (vc-mh715hm only) – Sharp VC-MH715HM User Manual
Page 18
14
www.sharp.co.uk/support
BASIC OPERATION
HOW TO USE THE VIDEO Plus+
®
SYSTEM TO MAKE A
RECORDING (VC-MH715HM ONLY)
6.
If you wish to change the
RECORDING
SPEED
, use the
[
/
]
to highlight SP. Press
[
/
] to select either standard play (SP),
long play (LP) or extended play (EP) as
required.
7.
Press the
SET
button to confirm the
programme. The VIDEO Plus+ system menu will
reappear. If you wish to enter further VIDEO
Plus+ system recordings repeat this procedure.
8.
When you have completed entering the timer
settings, press the
MENU
button to
remove the menu from the TV screen.
9.
Ensure that the tape on which you wish to
record is inserted into the VCR, then press the
TIMER ON/OFF
button once to place
the VCR in TIMER STANDBY mode.
will be
shown on the display.
NOTES:
•
You may also access the VIDEO Plus+ system menu by the following procedure:
i.
Press the
MENU
button.
ii.
The VIDEO Plus+ system option will be highlighted. Press the
SET
button to
confirm.
Continue from step 2 of this procedure.
•
If the
symbol flashes a video tape has not been inserted into the VCR.
•
If the video tape is ejected when the VCR tries to record the record protection tab has
been removed.
•
During recording, press
STOP
to cancel the recording. If there are further
recordings to be made, the VCR will return to Timer Standby.
1 / 2
DA T E P R
S T AR T
S T OP
2 1 / 0 6
0 2
1 2 : 0 0
1 3 : 0 0
S P
- - / - -
- -
- : - -
- : - -
- -
- - / - -
- -
- : - -
- : - -
- -
- - / - -
- -
- : - -
- : - -
- -
S P / L P :
T A P E
S P E E D
ǡ Ǡ : S E L EC T
į Ĭ : CHANGE
S E T
: E N T E R ME NU : E X I T
6.
→
P L U S COD E NO .
-
ONC E
WE E K L Y
DA I L Y
7
.
SET
SET
TINS-A079UMN1.book Page 14 Monday, November 4, 2002 1:01 PM