Sharp VC-MH715HM - Manual (Page 35)

31
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY SETTING THE CLOCK
This procedure will allow you to set the clock manually.
1. Press the MENU button.
2. Press the [ / ] menu select buttons to
select SET UP. Press the SET button to
confirm.
3. Press [ / ] to select CLOCK. Press the
SET button to confirm.
4. Press [ / ] to select either 12 or 24 hour
clock.
5. Press [ / ] to select TIME. Enter the time
using the NUMBER BUTTONS or the
[ / ] buttons. If the minutes or hours are
less than 10, enter the leading 0. If using the 12
hour clock enter AM or PM by pressing the
AM/PM button on the remote control.
6. Press [ / ] to select DATE. Enter the date
using the NUMBER BUTTONS or the
[ / ] buttons. For example, for 1st April
enter 01 04 .
7. Press [ / ] to select YEAR. Enter the last two
digits of the year using the NUMBER
BUTTONS or [ / ]. For example, for
2002 enter 02 . For the year 2003 enter 03.
8. Press the SET button to confirm.
NOTE:
• You will need to update the clock for Summer/Winter daylight saving.
S E T U P
CHANN E L P R E S E T
CHANN E L SOR T
C L OCK
į Ĭ : S E L EC T ǡ Ǡ : CHANGE
S E T : E N T E R ME NU : E X I T
C L OCK
MOD E T I ME DA T E Y E AR
2 4 H 0 : 0 0 0 1 / 0 4 0 2
MOD E : 2 4 H / 1 2 H
ǡ Ǡ : S E L EC T į Ĭ : CHANGE
S E T : E N T E R ME NU : E X I T
Remote Control
MENU SELECT
BUTTONS
MENU
SET
3.
4.
SET
SET
SET
TINS-A079UMN1.book Page 31 Monday, November 4, 2002 1:01 PM