Sharp VC-MH715HM - Manual (Page 32)

28
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
• It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1. Press MENU .
2. Press the [ / ] menu select buttons
to select SET UP. Press SET to confirm.
3. CHANNEL PRESET will be
highlighted. Press SET .
4. Press [ / ] to select CHANNEL .
5. VC-MH705LM only
IMPORTANT NOTE:
Press to select CH or CC. This will
determine whether off air (CH) or cable
(CC) is tuned first. Note that both off air
and cable will be tuned regardless of the
setting.
6. Press [ / ] to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press [ / ] to continue tuning.
7. Press [ / ] to select FINE
TUNING . Press and hold [ / ] until
the sharpest colour picture is obtained.
IMPORTANT NOTE
8. If you connect an independent decoder,
you must press [ / ] to select
DECODER, then select [ / ] to turn
the decoder function ON.
9. Press [ / ] to select SKIP .
The SKIP function determines whether the
channel can be selected when using the
CHANNEL / instead of the
NUMBER BUTTONS .Press [ / ]
to select ON or OFF for this option.
10. Press SET to confirm.
11. Press MENU to leave this function.
C H A N N E L P R E S E T
C H A N N E L S O R T
C L O C K
➔ P R E S E T 1
CHANN E L CH 2 1
F I N E T UN I NG ▲
▲
D E COD E R ON O F F
S K I P ON O F F
CABLE RECEPTION
VC-MH705LM only
Station
Signals VHF
Real
Channel
Numbers
A
B
C
D
E
F
G
H
J
01
02
03
04
05
06
07
08
09
SET
SET
SET
TINS-A079UMN1.book Page 28 Monday, November 4, 2002 1:01 PM