On-screen display – Sharp VC-MH715HM User Manual
Page 37
33
www.sharp.co.uk/support
MORE INFORMATION ABOUT YOUR VCR
ON-SCREEN DISPLAY
All the information you need on the VCR status will be summarised on the on-screen display.
If you are recording, playing back a tape or watching a broadcast on the video channel you
can call up three standard on-screen displays. The display can be selected by pressing the
MODE OSD
button on the remote control, 1,2,3 or 4 times.
1.
AUTO
, the current mode and channel
number will be displayed for 3 seconds when an
operation or number button is pressed.
2.
FULL
, all the active features will also be shown
on screen.
3.
COUNTER
, this display will show the tape
counter and amount of tape remaining.
4.
DISPLAY OFF
, this will remove the display
from the screen.
NOTES:
•
The default time and date will not be displayed if the clock has not been set.
•
The VCR will return to display
1
. each time it is switched on.
•
If you are recording from this VCR to another, make sure you remove the display from
the screen otherwise it will be recorded.
1.
■
1 CH 5 9
N I CAM
S T E R EO
S P
L
R
Programme number and channel
Tape Status
Sharp Super Picture Status
NICAM signal
Tape speed
Audio output mode
Time
Date
Tape remaining
Tape counter
2.
■
1 CH 5 9
S U P E R
P .
ON
N I CAM
S T E R EO
S P
L
R
2 2 : 0 0
R EM 1 : 0 5
9 / 0 7 0 2
0 : 0 0 . 0 0
REM 1:05
0:00.00
3.
TINS-A079UMN1.book Page 33 Monday, November 4, 2002 1:01 PM