Sharp JB940 - Manual (Page 27)

Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting T
ips
Customer Service
Care and cleaning of the range.
Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
Control Knobs
The control knobs may be removed for easier
cleaning.
Before removing the knobs for cleaning,
please note that the knobs are in the
OFF
position. When replacing the knobs,
check the OFF position to insure proper
placement.
Wash the knobs in soap and water or a
vinegar and hot water solution but do
not soak.
How to Remove Packaging Tape
To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive left from packaging tape on
new appliances is an application of a
household liquid dishwashing detergent,
mineral oil or cooking oil.
Apply with a soft cloth and allow to soak.
Wipe dry and then apply an appliance
polish to thoroughly clean and protect
the surface.
NOTE: The plastic tape (on some models) must
be removed from all chrome trim. It cannot be
removed if it is baked on.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is re-engaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
Control Panel
Deactivate the touch pads before cleaning.
See the Cooking/Self-Clean lockout
information in the Special features of
your oven control
section in this manual.
Clean up splatters with a damp cloth.
You may also use a glass cleaner.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Reactivate the touch pads after cleaning.
See the Cooking/Self-Clean lockout
information in the Special features
of your oven control
section in this
manual.
Oven Vent
The oven vent is located behind the right rear
surface unit.
This area could become hot during
oven use.
It is normal for steam to come out of the
vent and moisture may collect
underneath it when the oven is in use.
The vent is important for proper air circulation.
Never block this vent.
5
Molded flat area
Flat
Flat Stem
27
Spring clip
Clear groove
in stem
Molded rib
Groove Stem
The knob stem has a groove in each
side. The groove on one side has a
spring clip. The other groove is clear
(see illustration). Check the inside of
the knob and find the molded rib.
Replace the knob by fitting the molded
rib inside the knob into the clear
groove on the stem.
The knob stem is flat on one side (see
illustration). Check the inside of the
knob and find the molded flat area.
Replace the knob by fitting the molded
flat area inside the knob onto the flat
area of the stem.