Smart Technologies Smart Board 560 and 580 Interactive Whiteboards And UF55 Projectors 99-00964-20 - Manual (Page 7)

99-00964-20 A0 Important Information v
Other Precautions
To ensure operating safety and to prevent product damage, observe the following precautions.
• Turn off the SMART product before cleaning it.
• Use a soft lint-free cloth moistened with a mild detergent to clean the projector housing.
• Don’t use abrasive cleaners, waxes or solvents to clean your SMART product.
• Disconnect the power plug from the AC outlet if your SMART product is not being used for a long period
of time.
• Don’t block the ventilation slots and openings on the projector.
• Don’t place the interactive whiteboard system near any appliance that generates a strong magnetic field.
• Don’t place the interactive whiteboard system in direct sunlight.
• Don’t set up or use the interactive whiteboard system in an area with excessive levels of dust, dirt, humidity
or smoke.
• To reduce the risks associated with leaking batteries:
– use only a coin-cell type battery
– orient the battery’s plus (+) and minus (-) terminals according to the markings on the remote control
– don’t leave the battery in the remote control for an extended period
– don’t heat, disassemble, short or recharge the battery or expose it to fire or high temperatures
– avoid eye and skin contact if the battery has a leak
– dispose of the exhausted battery and product components in accordance with applicable regulations
• If the interactive whiteboard system requires replacement parts, make sure that the service technician uses
replacement parts specified by SMART Technologies, or parts with the same characteristics as the original.