Sennheiser EM 2000 - Manual (Page 26)

Adjusting settings via the operating menu
24
̈
Set the desired frequency bank.
̈
Set the desired channel.
̈
Set the desired frequency.
Changing the settings of the guitar tuner
The following settings are available:
Getting into the “Sync Settings” submenu
To get into the “ Sync Settings ” submenu (see page 26):
̈
From the extended menu “ Advanced Menu ”, select “ Sync Settings ”.
Activating/deactivating the pilot tone evaluation
The pilot tone supports the receiver’s squelch function and protects against interference due
to RF signals from other devices. The transmitter adds an inaudible pilot tone to the trans-
mitted signal. The receiver detects and evaluates the pilot tone, and is thus able to identify
the signal of the matching transmitter and mute all others.
If the pilot tone evaluation is activated, a “ P ” is displayed on the receiver display. If the “ P ” is
displayed inverted, the pilot tone transmission of the matching transmitter is activated.
Select the frequency
bank and confirm
Tune
B.Ch: U1 . 1
Select the channel;
store the setting
Tune
B.Ch: U2. 1
Select “Tune”
(special function)
Advanced Menu
543.200 MHz
543.200 MHz 543.200 MHz
Exit
Tune
Sync Settings
“Stored”
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
Tune
Guitar Tuner
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Setting Meaning
“ Active ” When selecting the “ Guitar Tuner ” standard display (see page 15),
the receiver is not muted.
“ Inactive ” The “ Guitar Tuner ” standard display is deactivated.
“ Audio Mute ” When selecting the “ Guitar Tuner ” standard display (see page 15),
the receiver is muted.
Tune
Guitar Tuner
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Tune
Guitar Tuner
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu