Sennheiser EM 2000 - Manual (Page 25)

Adjusting settings via the operating menu
23
Getting into the extended menu “Advanced Menu“
To get into the extended menu “ Advanced Menu ” (see page 23):
̈
From the main menu, select “ Advanced ”.
The extended menu “ Advanced Menu “
Setting the receiving frequencies and the frequency banks “U1” to “U6
Via the “ Tune ” menu item, you can set a receiving frequency to be stored in the current
channel or you can select a different channel and assign it a receiving frequency.
Setting a receiving
frequency for the
current channel
̈
Set the desired frequency.
Selecting a channel and
assigning this channel
a frequency
Squelch
Easy Setup
Setup
Frequency Preset
Name
AF Out
Equalizer
Auto Lock
Advanced
Exit
Menu
Tune
Guitar Tuner
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Factory Reset
IP-Address
Software Revision
Exit
Advanced Menu
When you have selected one of the system banks and then select the “ Tune ” menu,
the receiver automatically switches to channel 1 of the frequency bank “ U1 ”. In this
case, “ U1.1 ” briefly appears on the display panel.
Upon delivery, the channels of the frequency banks “ U1 ” to “ U6 ” are not assigned a
receiving frequency.
̈
Turn the jog dial until the “ Tune ” menu item appears.
̈
Press the jog dial.
The frequency selection appears.
It is vital to observe the notes on frequency selection on page 29.
̈
Press the jog dial.
Your settings are stored. The “
Tune ” menu item appears.
Select “Tune” Select the MHz value
and confirm Select the kHz value;
store the setting
Advanced Menu
543.200 MHz
Tune
B.Ch: U1. 1
543 .200MHz
Tune
B.Ch: U1. 1
548. 200 MHz
Exit
Tune
Sync Settings
“Stored”
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
̈
Turn the jog dial until the “ Tune ” menu item appears.
̈
Keep the jog dial pressed until the frequency bank selection appears.