Sharp Aquos LC 20DV20U - Manual (Page 28)

27
Connecting a PC (Personal computer)
Viewing an image from a PC
Use the INPUT5 (PC) terminals to connect a PC.
NOTE
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 28 for a list of PC signals compatible with the System.
• Make sure to select the same signal values for the output signal of a PC and the input signal of the TV/DVD
set before connecting with the PC. (See page 28.)
• Depending on the PC being used, images may not be shown without converting the output signals into
external output. Please refer to your PC’s manuals regarding converting to external output.
Signal names for 15-pin mini D-sub connecter
15 14 13 12
9
11
10 8 7 6
5 4 3 2 1
Pin No. Signal name Pin No. Signal name Pin No. Signal name
1 R 6 GND (Ground) 11 Not connected
2 G 7 GND (Ground) 12 SDA
3 B 8 GND (Ground) 13 HD
4 Not connected 9 +5V 14 VD
5 CSYNC 0 GND (Ground) 15 SCL
Connecting the RGB cable
• Connect the RGB cable making sure
that it fits correctly into the terminal.
Then, firmly secure the connectors
by tightening the screws on both
sides of the plug.
PC
RGB cable
(commercially available)
To AUDIO
input terminals To Audio output
terminals
To ANALOG
RGB terminal To ANALOG RGB
output terminal
Audio cable
(commercially available)
NOTE
• Pin No. 5 is not used for inputting the signal.
• Pin No. 9 is not connected with the supplied RGB cable.
Displaying an image from a PC
To view an image from a PC, perform the
following procedure.
1 Select the INPUT5 (PC) mode using INPUT
on the remote control or the TV/DVD. (See
page 19.)
2 Select the PC input signal. (See page 28.)
3 Adjust the “PICTURE.” items if the PC
image does not come in clearly. (See page 28.)
SOURCE SELECTION
0. TV
1. INPUT1
2. INPUT2
3. INPUT3
4. INPUT4
5. INPUT5
[0-5]:SELECT
5X20431A_P23_28.indd 27 5X20431A_P23_28.indd 27 5/19/2006 10:57:38 PM 5/19/2006 10:57:38 PM