Watching tv, Preparation, Turning on the power – Sharp Aquos LC 20DV20U User Manual
Page 14: Select the tv mode, Turning off the power, Changing channels, Changing volume/sound
13
Changing channels
You can change channels in several ways.
Simple operations for watching a TV program
POWER indicator
Turning on the power
Press POWER on the TV/DVD, or POWER on the
remote control.
• POWER indicator (Green): The TV/DVD is on.
NOTE
• The LANGUAGE setup menu will appear automatically
when TV MENU is pressed on for the fi rst time.
Turning off the power
Press POWER on the TV/DVD, or POWER on the
remote control.
• The TV enters standby mode and the image on the
screen disappears.
• The POWER indicator on the TV/DVD changes to Red.
NOTE
• If you are not going to use this TV/DVD for a long period
of time, be sure to remove the AC cord from the power
outlet.
• Weak electric power is still consumed even when
POWER is turned off.
• If a station being viewed stops broadcasting, the TV will
automatically shut itself off after 15 minutes.
Preparation
Perform the following steps before you press POWER
on the remote control unit.
1. Insert the batteries into the remote control unit.
(See page 8.)
2. Connect the antenna cable to the TV/DVD. (See page
12.)
3. Plug in the AC cord to the AC outlet. (See page 7.)
Watching TV
POWER
TV/DVD status indicator (POWER)
ON
Lighting (Green)
Lighting (Red)
OFF/Standby
To select a 3-digit channel number (e. g., Channel 115):
Press 1J1J5
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• If you push “0” by itself, nothing will happen.
• Complete the above steps within a few seconds.
Method 1
Using CH
/
on the remote control unit or on the
TV/DVD.
Method 2
Using remote control buttons 0
–
9 to select channels
for VHF/UHF/CATV.
To select a 1 or 2-digit channel number (e. g., Channel 5):
Press 5
VOLUME 25
Changing volume/sound
Changing the volume
You can change the volume on the TV/DVD or on the
remote control unit.
NOTE
• VOL+/– on the TV/DVD operates the same as VOL+/–
on the remote control unit.
Using VOL +/–
• To increase the volume, press
VOL +
.
• To decrease the volume, press
VOL –
.
MENU VOL +/– CH
/
Select the TV mode
Press TV/DVD to select the TV mode.
5X20431A_P01-15.indd 13
5X20431A_P01-15.indd 13
5/19/2006 10:51:32 PM
5/19/2006 10:51:32 PM