Sony VPD-MX10 User Manual
Page 9
9
GB
Location and Function of Controls
O
v
er
vi
ew
qs
Ventilation holes (intake)
• Do not place anything near the
ventilation holes as it may cause internal
heat build-up.
• Do not place your hand or objects near
the ventilation holes as it may cause the
air coming out heat build-up.
qd
Connector panel
For details, see “Connector Panel” on
page 11.
qf
Rear remote control detector
(SIRCS receiver)
How to open/close the front cover
To open the front cover
Press the OPEN button.
The front cover is opened and set on the
front of the projector.
To close the front cover
Restore the front cover by hand.
• Do not tilt the projector out of the range of
the adjuster setting when you open the
front cover. If the projector is tilted too
much, the front cover opens speedily or
slowly.
• The lamp goes out if the front cover is kept
closed while the power is on.
How to use the adjuster
To adjust the height
Adjust the height of the projector as follows:
1
Lift the projector and press the
adjuster adjustment buttons.
The adjusters will extend from the
projector.
2
While pressing the buttons, lower the
projector. Then, release the buttons.
For fine adjustment, turn the adjusters
to the right and the left.
• Be careful not to let the projector down
on your fingers.
• Do not push hard on the top of the
projector with the adjusters out.
It may be occurred malfunction.
Notes
Notes
Adjuster adjustment buttons
to lower the
projector
to raise the
projector